A/1K-2W-RSO-RJ4-LCD-C-A09-C5

A/20K-D-12"-PB - 20K Ohms @ 77 Deg F (25 Deg C) Thermistor The standard plastic duct mount configuration has a mounting flange for quick installation and a foam pad to dampen vibrations. The sensing element is double encapsulated to avoid sensor failures caused by moisture infiltration. ACI duct temperature sensors are designed for HVAC Building Automation and light industrial systems. Specific applications include: zone control air handling unit and temperature monitoring. Negative temperature coefficient Double encapsulated sensor Built in mounting flange Easy open/close latch sysetm (no screws)

AAR - The AAR is controlled by a single analog input signal with two potentiometers controlling each output relay. The two 10 amp output relays can be independently set to fixed or adjustable deadband. ?Fixed the relay will turn ?ON? at the level set by the Low pot and will turn ?OFF? at a fixed 3% of the input signal below the turn-on level. ?Adjustable? allows a flexible range of deadband adjustment using the High and Low potentiometer. The edge-connector feature allows signal and power connections to be extended to the next board. This allows the installer to wire the first unit then slide additional units together by plugging into a power and signal bus without the need to strip and terminate additional wires.  The AAR is covered by ACI's Two (2) Year Limited Warranty. Digital output expansio Level indicatio Alarms

ROOM SENSOR

Room Sensor w/SetPoint (addIn)

HUMIDITY SENSOR

3% Accuracy Duct Hum. Trans.

10K RoomTempSensor

8" 10K ohm THERMISTOR

Emerson Sensor w/ Plastic Box